5V 12V 24V Relay Module with Optocoupler Relay Output 1 2 4 6 8 16Way Relay Module for Automation Equipment Control(5V,6 Way)

Relays5VRelay coil drive voltage is 5V, input control level can also be within 5V Module Description: Output drive capacity: 250VAC-10A, 125VAC-10A, 30VDC-10A, 28VDC-10A; easy to use, simple 3-wire structure for each group of outputs, reserved for 6 output terminals; inputs are directly connected to the microcontroller IO port or digital circuits, input low level relay suction, input low level relay release; operating voltage 5V, suction current of about Operating voltage 5V, suction current about 70mA each way, with relay status indicator; all SMD components, reasonable drive circuit design, using 8050 transistor drive relay action; with fixed screw holes for easy installation.Simple test instructions: module input and output electrical insulation, for the corresponding correct voltage, just connect a low level on the input pin (such as a short circuit with VCC) will allow the relay to be absorbed, do not connect or connect a low level (such as a short circuit with GND) relay does not operate.12VParameters:There are 4 fixing screw holes around the board, the hole diameter is 3.1mm, which is convenient for installation and fixing.The relay uses relay, single pole double throw. a common end, a normally open end, and a normally closed end.Optocoupler isolation, good anti-interference.Low level pull-in, high level release. The status indicator is on when the inverter is closed, and the status indicator is off when released.VCC is the system power supply, and JD_VCC is the relay power supply.Electrical parameters:Supply voltage: DC 12VCurrent: greater than 100mALoad: 250V 10A AC or 30V 10A DCWiring instructions:VCC: system power supply positiveGND: system power supply negativeIN1--IN2: Relay Control Por24VParameters:There are 4 fixing screw holes around the board, the hole diameter is 3.1mm, which is convenient for installation and fixing.The relay uses relay, single pole double throw. a common end, a normally open end, and a normally closed end.Optocoupler isolation, good anti-interference.Low level pull-in, high level release. The status indicator is on when the inverter is closed, and the status indicator is off when released.VCC is the system power supply, and JD_VCC is the relay power supply.Electrical parameters:Supply voltage: DC 24VCurrent: greater than 100mALoad: 250V 10A AC or 30V 10A DCWiring instructions:VCC: system power supply positiveGND: system power supply negativeIN1--IN2: Relay Control Por

• Relays
• 5V 12V 24V Relay Module With Optocoupler Relay Output 1 2 4 6 8 16Way Relay Module For Automation Equipment Control